Connecting The Power Cord - Genicom microLaser 320 Installation Manual

Connecting the Power Cord

Connect the printer to an AC outlet as described below.
WARNING: To prevent the risk of electric shock, never touch the power cord or plug with wet
hands.
CAUTION: When disconnecting the power cord, always grasp the plug and do not pull at the
cable. Damage to the cord can lead to fire and electric shock.
Do not plug the printer into an AC outlet with incorrect voltage.
n
Do not use any multi-extension cord connector otherwise there is a risk of fire and electric shock.
n
Do not use extension cords with rated current less than 124V 15A. Never use extension cords with
n
low capacity, or extreme heat or flame may result. Consult your dealer on the correct type of extension
cord to use.
Do not damage or modify the extension cord. Also, do not bend, pull, or place heavy objects on the
n
extension cord otherwise the extension cord may be damaged and result in fire hazard or electric
shock.
See "Safety Notes" on page B-2.
n
Insert the power cord into the AC connector on the printer
1.
Jun 99
microLaser 320 and 401 Installation Guide
AC OUTLET POWERCORD
Genicom
For standard configuration
Publication No. GEK-89496C
1-17