Ibm Host Status - Genicom 5050 User Manual

IBM Host Status

Connection
LCD Message
Type
Ready
Twinax
06 ATTENTION
15 COMM CHECK
Ready
06 ATTENTION
08 HOLD TIME-
OUT
27 NOT ENABLED
28 NO CCU
Coax
SIGNAL
59 CANCEL
61 PA1
62 PA2
63 SEND STATE
I/F Settings
IBM Host Status
IBM Host Status
Enable<
5050/5100 User's Manual
If enabled and an IBM interface board is installed in Expansion slot 1
or 2, the control panel will display a status related to the IBM host.
The messages are dependent on the connection type, Twinax or Coax.
Meaning
Printer is Online and
communicating with the host.
Operator attention is requested
by the host.
No host communication.
Printer is Online and
communicating with the host.
Operation attention is
requested by the host..
The printer is Offline and the
time set in menu options IRQ
BSY TO or IRQ ERR TO has
expired.
Communications Failure.
No host communication.
Cancel requested. Will change
to "Ready" where cancel is
accepted by the host.
PA1 key requested. Will change
to "Ready" when the key is
accepted by the host..
PA2 key requested. Will change
to "Ready" when the key is
accepted by the host.
Printer placed in send state by
the host.
1. While in the I/F Settings menu, press the ◄ (left) or ► (right)
menu browse key until IBM Host Status is located in the lower
right corner of the LCD.
2. Press the ▼ (down) menu browse, or the Select key, to access the
IBM Host Status menu options.
3. Press the ◄ (left ) or ► (right) menu browse key until the desired
setting is displayed in the lower right corner of the LCD.
4. Press the Select key to enable or disable an option. The < symbol
will immediately follow an enabled option.
Action Required
None
See the system operator.
Check cabling.
None.
See the system operator.
Put the printer online.
Check cabling.
Check cabling.
Put the printer online.
Put the printer online.
Put the printer online.
See the system operator.
90
GEK-99044E