Select I/F; I/F Settings - Genicom 5050 User Manual

SELECT I/F

Set Up
Select I/F

I/F SETTINGS

Set Up
I/F Settings
I/F Settings
MultiSource
5050/5100 User's Manual
The Select I/F menu allows the operator to select a specific type of
interface the printer will be using. The factory default setting is
multisource, which activates all interfaces. The multisource setting is
sufficient for most applications. (See the Operator Menu Map in
Appendix I for available selections.)
Multiple interfaces can be selected. For example, Serial and
Parallel interfaces can be active at the same time. If a selection
other than Multisource is selected, the Multisource interface is
unselected. If Multisource is selected, all other interfaces are
automatically unselected.
1. While in Set Up menu, press the ◄ (left) or ► (right) menu browse
keys until Select I/F is displayed in the lower right corner of the
LCD.
2. Press the ▼ (down) menu browse key to access the interface
options.
3. Press the ◄ (left) or ► (right) menu browse keys until the
interface type desired is displayed in the lower right corner of the
LCD.
4. Press the Select key to select an interface type. The
now immediately follow the saved interface type.
This menu and its sub-menus are used to setup the printer's
interface options and the serial interface parameters. See the Set Up
Menu Map in Appendix I for available selections.
1. While in the Set Up menu, press the ◄ (left) or ► (right) menu
browse key until I/F Settings is displayed in the lower right corner
of the LCD.
2. Press the ▼ (down) menu browse key to access the sub-menu
options. I/F Settings will be displayed in the upper left corner of
the LCD.
3. Press the ◄ (left) or ► (right) menu browse key until the desired
interface is displayed. Press the Select key to select MultiSource,
Parallel Setup, Serial Setup, Expansion 1, or Expansion 2.
The following describes the selections available.
Note
71
<
symbol will
Chapter 5. Using the Setup Menu