Vertical Dpi; Lpi Grid; Version - Genicom 5050 User Manual

QMS

Vertical DPI

Vertical DPI
72<
QMS

LPI Grid

LPI Grid
Disable<
QMS

Version

Version
Ver I<
5050/5100 User's Manual
Vertical DPI
This menu selects the Vertical DPI setting for QMS. This specifies the
Vertical Dots Per Inch in Code V Version I. If set to 70 (72), a one-
inch (1") high character (as called for in a Magnum command) will be
70(72) of an inch high.
1. While in the QMS menu, press the ◄ (left) or ► (right) menu
browse key until Vertical DPI is displayed in the lower right corner
of the LCD.
2. Press the ▼ (down) menu browse key to access the Vertical DPI
options.
3. Press the ◄ (left) or ► (right) menu browse key until the desired
option is displayed. Press the Select key to enable or disable an
option. The < symbol will immediately follow an enabled option.
LPI Grid
This menu selects the LPI Grid setting for QMS. When enabled, a
linefeed <LF> after a graphics pass position printing at the next LPI
grid position. If disabled, a linefeed after a graphics move will move
the paper a full LPI increment.
Use the following procedure to select this option:
1. While in the QMS menu, press the ◄ (left) or ► (right) menu
browse key until LPI Grid is displayed in the lower right corner of
the LCD.
2. Press the ▼ (down) menu browse key to access the LPI Grid
options.
3. Press the ◄ (left) or ► (right) menu browse key until the desired
option is displayed. Press the Select key to enable or disable an
option. The < symbol will immediately follow an enabled option.
Version
This menu selects the Version for QMS. This feature is provided for
users of Code V Version I programming which utilized rotated
MAGNUM characters. Elongation of characters could cause print line
length to be exceeded. Setting this option to Ver I, will prevent
character elongation from causing print line overflow.
1. While in the QMS menu, press the ◄ (left) or ► (right) menu
browse key until Version is displayed in the lower right corner of
the LCD.
2. Press the ▼ (down) menu browse key to access the Version
options.
3. Press the ◄ (left) or ► (right) menu browse key until the desired
option is displayed. Press the Select key to enable or disable an
option. The < symbol will immediately follow an enabled option.
103
Chapter 5. Using the Setup Menu