Ignore Char; Form Length=0 - Genicom 5050 User Manual

IGP

Ignore Char

Ignore Char
00
IGP

Form Length=0

Form Length=0
Normal<
5050/5100 User's Manual
Ignore Char
This menu option is used to set the hexadecimal value of the received
data character to be ignored when the Ignore Chr Mode is enabled
(See previous option). The valid range of hexadecimal values is 0X00
to 0XFF.
Use the following procedure to select this option:
1. While in the IGP menu, press the ◄ (left) or ► (right) menu
browse key until Ignore Character is displayed in the lower right
corner of the LCD.
2. Press the Select key to access the Ignore Character options.
3. This option is user set. Notice the cursor (underline) is now
shown under the first digit. The horizontal ◄ ► (left or right)
menu browse keys to position the cursor (underline) under the
digit to be changed; the vertical ▲ ▼ (up or down) menu browse
key increment/decrement the selected alphanumeric digit by one.
Enter the hex value of the character desired.
4. Press the Select key after all changes are complete and the
desired value is displayed in the lower right corner of the LCD.
Repeat this step if further changes are necessary.
5. Press the Clear key to exit this option.
Form Length=0
With Normal enabled, the printer will logically advance by the <FF>
command after processing an execution command. This is the default
factory-set condition. The user may set this option to Ignore and the
printer will not logically advance by the <FF> command.
1. While in the IGP menu, press the ◄ (left) or ► (right) menu
browse key until Form Length=0 is displayed in the lower right
corner of the LCD.
2. Press the ▼ (down) menu browse key to access the Form
Length=0 options.
3. Press the ◄ (left) or ► (right) menu browse key until the desired
option is displayed. Press the Select key to enable or disable an
option. The < symbol will immediately follow an enabled option.
98
GEK-99044E