Debug Platform Messaging Application - Cisco Catalyst 3750 Command Reference Manual

Appendix B Catalyst 3750 Switch Debug Commands

debug platform messaging application

Use the debug platform messaging application privileged EXEC command to enable debugging of
application messaging activity. Use the no form of this command to disable debugging.
Syntax Description all
badpak
cleanup
events
memerr
messages
stackchg
usererr
Defaults Debugging is disabled.
Command Modes
Privileged EXEC
Command History Release
12.1(11)AX
Usage Guidelines
The undebug platform messaging application command is the same as the no debug platform
messaging application command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
78-16181-03
debug platform messaging application {all | badpak | cleanup | events | memerr | messages |
stackchg | usererr}
no debug platform messaging application {all | badpak | cleanup | events | memerr | messages
| stackchg | usererr}
Display all application-messaging debug messages.
Display bad-packet debug messages.
Display clean-up debug messages.
Display event debug messages.
Display memory-error debug messages.
Display application-messaging debug messages.
Display stack-change debug messages.
Display user-error debug messages.
Modification
This command was introduced.
debug platform messaging application
Catalyst 3750 Switch Command Reference
B-51