Show Auto Qos - Cisco Catalyst 2960 Command Reference Manual

Hide thumbs Also See for Catalyst 2960:
Table of Contents

Advertisement

Chapter 2 Catalyst 2960 Switch Cisco IOS Commands

show auto qos

To use this command, the switch must be running the LAN Base image.
Note
Use the show auto qos user EXEC command to display the quality of service (QoS) commands entered
on the interfaces on which automatic QoS (auto-QoS) is enabled.
Syntax Description
interface [interface-id]
Command Modes
User EXEC
Command History
Release
12.2(40)SE
12.2(25)FX
Usage Guidelines
The show auto qos command output shows only the auto-QoS command entered on each interface. The
show auto qos interface interface-id command output shows the auto-QoS command entered on a
specific interface.
Use the show running-config privileged EXEC command to display the auto-QoS configuration and the
user modifications.
Beginning in Cisco IOS Release 12.2(40)SE, the show auto qos command output shows the service
policy information for the Cisco IP phone.
To display information about the QoS configuration that might be affected by auto-QoS, use one of these
commands:
Examples
This is an example of output from the show auto qos command after the auto qos voip cisco-phone and
the auto qos voip cisco-softphone interface configuration commands are entered:
Switch> show auto qos
GigabitEthernet0/4
OL-8604-04
show auto qos [interface [interface-id]]
Modification
The information in the command output changed.
This command was introduced.
show mls qos
show mls qos maps cos-dscp
show mls qos interface [interface-id] [buffers | queueing]
show mls qos maps [cos-dscp | cos-input-q | cos-output-q | dscp-cos | dscp-input-q |
dscp-output-q]
show mls qos input-queue
show running-config
(Optional) Display auto-QoS information for the specified port or
for all ports. Valid interfaces include physical ports.
Catalyst 2960 Switch Command Reference
show auto qos
2-299

Advertisement

Table of Contents
loading

Table of Contents