Show Auto Qos - Cisco Catalyst 2950 Command Reference Manual

show auto qos

show auto qos
Use the show auto qos user EXEC command to display the quality of service (QoS) commands entered
on the interfaces on which automatic QoS (auto-QoS) is enabled.
This command is available only if your switch is running the enhanced software image (EI).
Syntax Description
interface [interface-id]
Command Modes
User EXEC
Command History Release
12.1(12c)EA1
12.1(20)EA2
Usage Guidelines In releases earlier than Cisco IOS Release 12.1(20)EA2, the show auto qos [interface [interface-id]]
command output shows the initial generated auto-QoS configuration.
In Cisco IOS Release 12.1(20)EA2 or later, the show auto qos command output shows only the
auto-QoS command entered on each interface. The show auto qos interface interface-id command
output shows the auto-QoS command entered on a specific interface.
Use the show running-config privileged EXEC command to display the auto-QoS configuration and the
user modifications.
To display information about the QoS configuration that might be affected by auto-QoS, use one of these
commands:
•
•
•
•
•
•
Catalyst 2950 and Catalyst 2955 Switch Command Reference
2-272
show auto qos [interface [interface-id]]
Modification
This command was introduced.
The information in the command output changed, and the user guidelines
were updated.
show mls qos
show mls qos map cos-dscp
show mls qos interface
show running-config
show wrr-queue bandwidth
show wrr-queue cos-map
Chapter 2
(Optional) Display auto-QoS information for the specified
interface or for all interfaces. Valid interfaces include physical
ports.
Catalyst 2950 and 2955 Cisco IOS Commands
0L-10102-01