Replacing Expansion Cards; Preliminary Steps - Fujitsu PRIMERGY RX2540 M2 Upgrade And Maintenance Manual

8.4.3

Replacing expansion cards

Upgrade and Repair Unit
(URU)
Tools: Phillips PH2 / (+) No. 2 screw driver
Note on network settings recovery
I
When replacing network controllers or the system board, network
configuration settings in the operating system will be lost and replaced
by default values. This applies to all static IP address and LAN teaming
configurations.
Ensure to note down your current network settings before replacing a
controller or the system board.
8.4.3.1

Preliminary steps

Ê If applicable, "Note on network settings recovery" on page
"Suspending BitLocker functionality" on page 95
Ê
"Disabling SVOM boot watchdog functionality" on page 96
Ê
"Locating the defective server" on page 61
Ê
"Shutting down the server" on page 65
Ê
"Disconnecting the power cord" on page 66
Ê
Ê Remove all external cables from the expansion card to be replaced.
"Getting access to the component" on page 68
Ê
Ê Locate the defective expansion card using the onboard Local Diagnostic
LEDs as described in section
page 584.
RX2540 M2
"Onboard indicators and controls" on
Upgrade and Maintenance Manual
Expansion cards and backup units
Hardware: 5 minutes
Software: 5 minutes
261.
261