Configuration Commands
dhcpserver
Cisco RV34xx Router CLI Reference Guide
The CLI configuration commands allow users to configure, monitor and maintain
the router. All CLI configuration commands are listed in this chapter:
The dhcpserver commands allow network devices to automatically obtain a valid
IP address from a server. All the dhcpserver commands are listed here:
•
dhcpserver config
default-gateway-IP-address
•
dhcpserver reserving {add | delete}
address
•
dhcpserver show vlan
dhcpserver config
leased-time default-gateway-IP-address
To configure the dhcpserver, use the dhcpserver config
end-IP-address leased-time default-gateway-IP-address command
Parameters
vlanID - Enter the vlan ID
start-IP-address
- Enter the start IP address
end-IP-address
- Enter the end IP address
leased-time
(hour) - Enter the leased time in hours
default-gateway-IP-address - Enter the default gateway IP address
vlanID start-IP-address end-IP-address leased-time
vlanID description IP-address MAC-
X
vlanID start-IP-address end-IP-address
4
vlanID start-IP-address
.
22