Download  Print this page

Configuring L2vpn Quality Of Service; Restrictions; Configuring An L2vpn Quality Of Service Policy In Port Mode - Cisco CRS Configuration Manual

Ios xr virtual private network.
Hide thumbs

Advertisement

Configuring L2VPN Quality of Service

Configuring L2VPN Quality of Service
This section describes how to configure L2VPN quality of service (QoS) in port mode and mode, VLAN
mode, Frame Relay and ATM sub-interfaces.

Restrictions

The l2transport command cannot be used with any IP address, L3, or CDP configuration.

Configuring an L2VPN Quality of Service Policy in Port Mode

This procedure describes how to configure an L2VPN QoS policy in port mode.
In port mode, the interface name format does not include a subinterface number; for example,
Note
GigabitEthernet0/1/0/1.
SUMMARY STEPS
1. configure
2. interface type interface-path-id l2transport
3. service-policy [ input | output ] [ policy-map-name ]
4. Use the commit or end command.
DETAILED STEPS
Step 1
configure
Example:
RP/0/RP0/CPU0:router# configure
Enters the configuration mode.
Step 2
interface type interface-path-id l2transport
Example:
RP/0/RP0/CPU0:router(config)# interface GigabitEthernet 0/0/0/0
Configures an interface or connection for L2 switching and specifies the interface attachment circuit.
Step 3
service-policy [ input | output ] [ policy-map-name ]
Example:
RP/0/RP0/CPU0:router(config-if)# service-policy input servpol1
Attaches a QoS policy to an input or output interface to be used as the service policy for that interface.
Cisco IOS XR Virtual Private Network Configuration Guide for the Cisco CRS Router, Release 6.1.x
24
Implementing Point to Point Layer 2 services

Advertisement

Table of Contents

   Also See for cisco CRS

   Related Manuals for cisco CRS

Comments to this Manuals

Symbols: 0
Latest comments: