Configuring An Llq Policy Map - Cisco ASR 900 Series Configuration Manual

Port-Shaper and LLQ in the Presence of EFPs
Command or Action
Step 4
class class-default
Example:
Device(config-pmap)# class class-default
Step 5 shape-average shape-value
Example:
Device(config-pmap-c)#shape average
200000000
Step 6 service-policy policy-map-name
Example:
Device(config-pmap-c)# service-policy
child-llq

Configuring an LLQ Policy Map

SUMMARY STEPS
1. enable
2. configure terminal
3. policy-map policy-map-name
4. class class-map-name
5. priority
6. exit
7. class class-map-name
8. shape average value
9. exit
10. class class-map-name
11. bandwidth percent
12. exit
DETAILED STEPS
Command or Action
Step 1
enable
QoS: Policing and Shaping Configuration Guide, Cisco IOS XE Release 3S (Cisco ASR 900 Series)
Purpose
Assigns the traffic class you specify to the policy map and
enters QoS policy-map class configuration mode.
Configures a shape entity with a Comitted Information Rate of
200 Mb/s.
Applies the child policy to the parent class-default class.
• child-llq is the name of the child policy map configured
in Configuring Class-default Port-Shaper Policy Maps,
on page 25.
Purpose
Enables privileged EXEC mode.
Configuring an LLQ Policy Map
27