Ip Source-Guard Tcam Retries-Freq - Cisco SPS2024 Reference Manual

IP Source Guard Commands

ip source-guard tcam retries-freq

ip source-guard tcam retries-freq
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide
Example
The following example configures the static IP source bindings on the switch.
Console(config)# ip source-guard binding 00:01:01:02:02:02 1
192.168.2.10 ethernet e2
The ip source-guard tcam retries-freq Global Configuration mode command
configures the frequency of retries for TCAM resources for inactive IP source
guard addresses. Use the no form of this command to return to the default
configuration.
Syntax
ip source-guard tcam retries-freq {
no ip source-guard tcam retries-freq
Parameters
•
seconds
— Specifies, in seconds, the retries frequency. (Range: 10 – 600)
•
never — Specifies to not perform an automatic search for TCAM resources.
Default Configuration
The default value is 60.
Command Mode
Global Configuration mode.
seconds
| never}
16
229