Did Table [10-3] - Panasonic KX-TDA100 Features Manual

4.16.3 DID Table [10-3]

Incoming CO line calls with DID numbers can be distributed to specific destinations. Each DID number has
a destination programmed for each time mode (day/lunch/break/night).
When CLI distribution is enabled for a DID number, incoming CO line calls with that DID number will be
distributed to the CLI destinations (instead of the DID destinations) if the caller's identification number is
found in the System Speed Dialing Table, which is used as the Caller ID Table. CLI distribution can be
enabled or disabled for each time mode (day/lunch/break/night) on a DID number basis.
A maximum of 1000 DID numbers can be programmed with other related parameters in locations 1–1000.
Select the desired location from the Location list.
It is possible to program DID numbers and DID destinations in each time mode (day/lunch/break/night) for
a set of locations in series at once by clicking Automatic Registration, or to program DID names for a set
of locations in series at once by clicking Name Generate.
DID Number
Specifies the DID number.
Default
Not stored.
Value Range
Max. 32 digits (consisting of 0–9)
Programming Guide References
4.16.4 DID Table [10-3] Automatic Registration
Feature Guide References
1.1.1.3 Direct Inward Dialing (DID)
DID Name
Specifies the name for the DID number which is shown on the extension's display when receiving a call with
the DID number. The name of the DID number can be printed out on SMDR. As for the available characters,
refer to the character code table described in section 3.2.1 Installing and Starting KX-TDA Maintenance
Console.
Default
Not stored.
Value Range
Max. 20 characters
Programming Guide References
4.17.1 SMDR [11-1]—DID Print format
Feature Guide References
1.1.1.3 Direct Inward Dialing (DID)
4.16 CO & Incoming Call [10]
Feature Guide 735