Panasonic KX-TDA100 Features Manual page 344

4.7 Configuration [1]
OPB3 card: 2 with KX-TDA100, 4 with KX-TDA200
CTI-LINK card: 1 with KX-TDA100, 1 with KX-TDA200
Installation Manual References
1.3.1 Options
Programming Guide References
4.7.3 Slot [1-1] Extension Card Property
4.7.4 Slot [1-1] CSI/F Card Property
4.7.5 Slot [1-1] LCO Card Property
4.7.6 Slot [1-1] PRI Card Property
4.7.7 Slot [1-1] T1 Card Property
4.7.8 Slot [1-1] IP-GW Card Property
4.7.10 Slot [1-1] OPB
4.7.12 Slot [1-1] CTI-LINK Card Property
Feature Guide References
None
Status
Indicates the status of the service card in each slot (reference only).
This column offers two ways to open the screen to select the card command:
• Click the desired cell in the column.
• Use the arrow key to select the desired cell in the column, and then click Command.
Default
Slot 00: - (fixed)
Other slots: Current status
Value Range
INS: The card is in service.
OUS: The card is out of service.
Fault: The card has been removed from the slot, or is not communicating with the PBX.
Fault-OVER: The number of CO line and/or extension ports exceed the system capacity.
Fault-DIF: The card installed in the slot differs from the programmed card type.
Pre-Install: There is no card in the slot, but the card type is programmed for the slot.
Idle: There is no card in the slot, nor programming of the card type for the slot.
Programming Guide References
4.7.13 Slot [1-1] Card Command
Feature Guide References
None
344 Feature Guide