Panasonic KX-TDA100 Features Manual page 335

A • Yes. This is possible in Batch mode.
Create a new system data file using File—New (see "4.2.1 File—New"), edit settings as
required, and then upload this file to the PBX later (see "4.5.2 Utility—File Transfer PC
to PBX (SD Card)").
Modified settings have not been updated in the PBX.
Q
A • Click Apply or OK in the sub-menu screen.
Q If I reset the PBX directly after modifying settings, the modified settings are not
updated in the PBX.
A • When you click Apply, the settings are updated in the PBX, but are not yet saved to the
SD memory card. If system data is not saved to the SD memory card, the PBX will restore
the data that was last saved to the card in the event that the PBX is reset, or power is
turned off and back on again.
Therefore, before resetting the PBX, click the SD memory backup icon to save the
system data to the SD memory card. Alternatively, exit the Maintenance Console. This
automatically saves system data to the SD memory card.
Note
Do not remove the SD memory card during access. Doing so may result in failure to back
up data correctly.
Q After reinitialising the PBX, I restored system data from a previous backup.
However, some of the settings have not been restored to their previous values.
A • The following setting data is not saved to the SD memory card, so will be deleted when
the PBX is initialized. This data is stored in the PBX's battery backup memory.
• Present Button Status of extension FWD/DND
• Status of Group FWD
• Call logs
• Digital Trunk Error Report
• Status of Station Lock
• Status of Login
• Charge amount
Q Not all of the characters of a setting can be displayed because the column is
too narrow.
A • Move the mouse to the line between the names of 2 setting items, at the top of the table.
The pointer should change to a double arrow. Click and drag the line to the right until all
characters are displayed.
Q How do I set card status to "INS"?
A • In the Configuration—Slot screen (see "4.7.1 Slot [1-1]"), click the Status cell of the
card, and select "INS".
Q How do I set card status to "OUS"?
A • In the Configuration—Slot screen (see "4.7.1 Slot [1-1]"), click the Status cell of the
card, and select "OUS".
Q The status of a new card will not change to "INS".
4.6 Help
Feature Guide 335