Line Preference-Outgoing - Panasonic KX-TDA100 Features Manual

1.5 Making Call Features
Feature
CO Line Access
1.5.5.2 Line Preference—Outgoing
Description
Through personal programming, a proprietary telephone (PT) user can select the preferred method of
seizing a line (Preferred Line Assignment—Outgoing) that is used each time the user goes off-hook.
Method
Intercom
Idle Line
No Line
Prime Line
Conditions
• Line Preference Override
A user can override the preset Line Preference temporarily by pressing the desired Line Access button
or a Memory Dialing button, such as One-touch Dialing, before going off-hook.
• To select Idle Line Preference, the CO line groups available to the extension should be programmed
on a Class of Service (COS) basis (→ CO Line Group Number [500]). Also CO line groups available
for Idle Line Access should be assigned (→ Idle Line Access (Local Access) [103]).
• If Idle Line Preference or Prime Line Preference has been set for an extension, a CO line may be
automatically seized and placed on hold when the user goes off-hook and uses a DSS button to access
another extension. To avoid this problem:
1.
Set TRS for the extension to a level other than 1.
2.
Make sure that at least one TRS Denied Code for Level 2 has been defined. If there are currently
no Denied Codes for Level 2, store "000" in the Denied Code Table for Level 2.
When the user goes off-hook and presses a DSS button, the TRS feature is activated but the TRS
check is not complete, so the automatically seized CO line is disconnected.
Feature References
1.8.1 Toll Restriction (TRS)
Operation References
3.1.2 Settings on the Programming Mode
70 Feature Guide
Description
A user can select the CO Line Access method every time
a CO line call is made.
When an extension user goes off-hook, an extension line is selected
automatically.
When an extension user goes off-hook, an idle CO line is selected
automatically from the assigned CO line groups.
When an extension user goes off-hook, no line is selected. In order to make
a call, the user must select the desired line manually.
When an extension user goes off-hook, the preset line is selected
automatically. A prime line can be selected from the Line Access buttons: S-
CO, G-CO, L-CO, G-DN.
Description
Details in
• 1.5.5.3 CO Line
Access