Panasonic KX-TDA100 Features Manual page 103

• An extension user cannot originate a call from the SLT if the APT is:
– playing background music (BGM)
– receiving a paging announcement over the built-in speaker.
• The SLT will always ring for incoming calls (if its ringer is turned on). It cannot be programmed to not
ring.
[DPT + SLT]
• When in the parallel mode, XDP mode of the Super Hybrid port should be turned off through system
programming.
• Whether the SLT rings for incoming calls is programmable.
Ring on: Both telephones ring when a call is received, except for when the digital proprietary telephone
(DPT) is in Hands-free Answerback mode (→ 1.4.1.4 Hands-free Answerback) or voice-calling mode
(Alternate Receiving Ring/Voice) (→ 1.5.3 Intercom Call).
Ring off: Only the DPT rings when a call is received; however, the SLT can be used to answer the call.
• If one telephone goes off-hook while the other is on a call, the call is switched to the telephone that goes
off-hook. Note, however, that the call will not be switched when the extension is:
a)
Being monitored by another extension. (→ 1.5.3 Intercom Call)
b)
Receiving an Off-hook Call Announcement (OHCA) (→ 1.7.4.3 Off-hook Call Announcement
(OHCA)) or Whisper OHCA. (→ 1.7.4.4 Whisper OHCA)
c)
On a conference call (→ 1.13.1 Conference Features).
d)
Using Live Call Screening (LCS) or Two-way Record is activated (→ 1.21.2 Voice Mail DPT
(Digital) Integration).
[DPT + DPT]
• Available Telephones
KX-T7600 series (except KX-T7640)
• Digital XDP connection enables the maximum number of DPTs that the PBX supports to be increased.
This increase is only available when an MEC card and high-capacity power supply unit are installed.
• The following features cannot be used on either the master or slave DPT:
a)
OHCA: A call waiting tone will be heard even if the OHCA feature is set.
b)
USB Module: The DPTs will not function properly if a USB Module is attached to either DPT. Do
not connect a USB Module to either of the DPTs.
Note
To cancel a Digital XDP connection, disconnect the slave DPT from the master, then disconnect and
reconnect the master DPT to the PBX.
[DPT + DPT + SLT]
• When an SLT is connected to the slave DPT in parallel mode, the SLT acts as a parallel extension of
the master DPT. If connected in XDP mode, the SLT acts as an independent extension.
Connection References
2.7.2 Parallel Connection of the Extensions
2.7.3 Digital EXtra Device Port (Digital XDP) Connection
1.10 Conversation Features
Feature Guide 103