Panasonic KX-TDA100 Features Manual page 223

IP-GW-QSIG
IP data is routed through the network according to the routing tables of the IP-GW cards. When using
VoIP, it is necessary to identify the monitor PBX, to which to transmit extension status information, for
each card that will be used. This is done by specifying the extension number of any extension (for
example, the PBX operator) at the monitor PBX.
Network Operator Extn. No.
1001
[Example VoIP Network]
Network
4001 NDSS
Idle
Busy
Mixed Network
When using the NDSS feature over a mixed network containing both VoIP portions and ISDN line
portions, it is possible to set whether status information will be transferred between VoIP and ISDN
cards within each PBX. For example, if the monitor PBX is on a VoIP network, and monitored PBXs are
on an ISDN network, the PBX that acts as a gateway between the VoIP and ISDN networks must have
this setting enabled for ISDN to VoIP.
4.
Network Monitor Extension Registration [Monitor PBX]
Register the extensions (attached to other PBXs) that will be monitored. A maximum of 32 extensions
can be registered. Only extensions that have been registered here can be assigned to NDSS buttons.
Network Monitor Extensions Table
Index No.
001
002
003
:
032
When using the PBX Access Code numbering method, the relevant access code must be added before
the extension number registered here.
5.
NDSS Button Customization [Monitor PBX]
At any extension attached to the monitor PBX, customize a flexible button as an NDSS button for an
extension registered above. Then go off-hook, press this button once, and go on-hook again. This
activates the monitoring function. The monitored PBX will begin to transmit information about the status
IP-GW Card Slot No.
01
PBX-1
ID 1
IP Network
PBX-3
Network Extn. No.
2001
2002
4001
:
1.27 Networking Features
PBX-2
PBX-4
Network
ID 2
4001
Idle
Network Extn. Name
Branch 1: T. Jones
Branch 1: M. Davidson
Branch 2: R. Powell
:
Feature Guide
Busy
223