Dialing Plan [6-7] - Panasonic KX-TDA100 Features Manual

ARS Mode
Specifies the ARS mode used when making a CO line call.
Default
Same as System Setting
Value Range
Off: ARS is disabled.
On for Local Access Operation: ARS operates when an extension user makes a call using any Idle Line
Access method.
On for Any CO Access Operation: ARS operates when an extension user makes a call using any CO Line
Access method.
Same as System Setting: The setting specified in ARS Mode in System Setting [8-1] is applied.
Programming Guide References
4.14.1 System Setting [8-1]
Feature Guide References
1.9.1 Automatic Route Selection (ARS)
2.2.3 Tenant Service
System Speed Dial
Specifies which system speed dialing table is used by the tenant. This setting is only available when an MEC
card is installed.
Default
Same as System Setting
Value Range
Same as System Setting: PBX common system speed dialing numbers are used.
Tenant Exclusive: Individual tenant system speed dialing numbers are used.
Programming Guide References
4.12.1 Speed Dialing & Caller ID—Main Table [6-1-1]
Feature Guide References
1.6.1.4 Speed Dialing—Personal/System

4.12.9 Dialing Plan [6-7]

The PBX sends all of the dialed digits at once after an extension user completes dialing. The PBX can
recognize the end of dialing when the dialed telephone number starts with the programmed leading number
and contains the programmed total number of digits.
When the PBX recognizes the end of dialing to an analog CO line, the PBX cancels the muting of the caller's
voice sent to the analog CO line immediately. If the PBX cannot recognize the end of dialing, the PBX mutes
the caller's voice sent to the analog CO from the time at which the last digits is dialed until the analog CO
4.12 Feature [6]
Feature Guide 703