System Configuration-Hardware; Extension Port Configuration - Panasonic KX-TDA100 Features Manual

2.1 System Configuration—Hardware
2.1 System Configuration—Hardware
2.1.1

Extension Port Configuration

Description
There are three types of extension ports, used to connect digital proprietary telephones (DPTs), analog
proprietary telephones (APTs), single line telephones (SLTs), Cell Stations (CSs), DSS Consoles, and Voice
Processing Systems (VPS) to the PBX. The devices which can be connected to each type of port are listed
below.
a)
DPT Port: DPT, DSS Console, Panasonic VPS which supports DPT (Digital) Integration, and PT-
interface CS (e.g., KX-TDA0141)
b)
SLT Port: SLT and VPS which supports DTMF Integration
c)
Super Hybrid Port: DPT, APT, SLT, DSS Console, VPS, and PT-interface CS
EXtra Device Port (XDP):
A Super Hybrid port can be used as an XDP port, allowing two telephones (a DPT and an SLT) to be
connected to the same port of the PBX. This XDP port can be used in one of the following modes:
Mode
XDP Mode
XDP Parallel Mode
Conditions
• Automatic Detection on Super Hybrid Port
A DPT, APT, SLT, or CS can be connected to a Super Hybrid port with no programming required.
• A DSS Console or a Panasonic VPS which supports DPT (Digital) Integration can also be connected
with an SLT in XDP mode.
• APT and SLT in Parallel Mode
An APT and an SLT can also be connected to a Super Hybrid port and used in parallel mode.
• Digital XDP
A DPT can be connected to another DPT and act as an independent extension with its own extension
number. (→ 1.10.9 Paralleled Telephone)
• Wireless XDP Parallel Mode
A PS can be used in Wireless XDP Parallel mode with a wired telephone.
(→ 1.22.3 Wireless XDP Parallel Mode)
• DSS Console and Paired Telephone Assignment
When a DSS Console is connected, a PT must be paired with the DSS Console through system
programming (→ Console Paired Telephone [007]).
230 Feature Guide
The DPT and SLT have different extension numbers and act as independent
extensions. To use XDP mode, XDP mode must be enabled for the port through
system programming (→ EXtra Device Port (XDP) Mode [600]).
The DPT and an SLT share the same extension number so that they can act as
one extension. The SLT uses the extension data (extension number, Class of
Service [COS], etc.) of the DPT. (→ 1.10.9 Paralleled Telephone)
Description