Data Line Security; Flash/Recall/Terminate - Panasonic KX-TDA100 Features Manual

1.10.5 Data Line Security

Description
Once Data Line Security is set on an extension, communication between the extension and the other party
is protected from signals such as Call Waiting, Hold Recall and Executive Busy Override. Extensions which
have devices connected to them such as modems or fax machines may set this feature to maintain secure
data transmission, by blocking tones or other interruptions during communication.
Operation References
1.7.8 Data Line Security

1.10.6 Flash/Recall/Terminate

Description
A proprietary telephone (PT) user can use the FLASH/RECALL button (Flash/Recall mode or Terminate
mode) or Terminate button (Terminate mode) to disconnect the current call and originate another call without
hanging up.
Flash/Recall Mode: Disconnects the line and the extension user hears the dial tone from the line used last.
For example, if a CO line call is disconnected, the extension user will hear a new dial tone from the same
CO line.
Terminate Mode: Disconnects the line and the extension user hears a dial tone via the preferred CO line.
(→ 1.5.5.2 Line Preference—Outgoing)
Conditions
• FLASH/RECALL Button Mode
One of the following modes can be selected for each extension through system programming:
– Flash/Recall mode
– Terminate mode
– EFA mode. (→ 1.10.7 External Feature Access (EFA))
• Terminate Button
Any flexible button can be customized as the Terminate button.
• Disconnect Time (Only for Flash/Recall Mode)
The amount of time between successive accesses to the same CO line is programmable for each CO
line port (→ LCOT Disconnect Time [418]).
• This feature generates a Station Message Detail Recording (SMDR) call record (→ 1.23.1 Station
Message Detail Recording (SMDR)), restarts the call timer, inserts a pause, and checks the Toll
Restriction (TRS) level (→ 1.8.1 Toll Restriction (TRS)) again.
• If Automatic Route Selection (ARS) is used (→ 1.9.1 Automatic Route Selection (ARS)) or if a CO line
call is established using the INTERCOM button or G-DN button, Terminate mode will be effective even
when Flash/Recall mode has been set.
Feature References
1.18.2 Flexible Buttons
1.10 Conversation Features
Feature Guide 99