10-3] Did Table - Panasonic KX-NCP500 Programming Manual

12.3 [10-3] DID Table

Incoming CO line calls with DID numbers can be distributed to specific destinations. Each DID number has a
destination programmed for each time mode (day/lunch/break/night).
When CLI distribution is enabled for a DID number, incoming CO line calls with that DID number will be
distributed to the CLI destinations (instead of the DID destinations) if the caller's identification number is found
in the System Speed Dialing Table, which is used as the Caller ID Table. CLI distribution can be enabled or
disabled for each time mode (day/lunch/break/night) on a DID number basis.
A maximum of 1000 DID numbers can be programmed with other related parameters. 100 numbers are
displayed at a time. To display other sets of numbers, click the applicable tab.
To assign DID destination numbers, enter directly or click Destination Setting (see 2.1.6 Extension Number
Setting). It is possible to program DID numbers and DID destinations in each time mode (day/lunch/break/
night) for a set of locations in series at once by clicking Automatic Registration, or to program DID names
for a set of locations in series at once by clicking Name Generate.
DID Number
Specifies the DID number.
Default
Not stored.
Value Range
Max. 32 digits (consisting of 0–9, *, and #)
Maintenance Console Location
12.3 [10-3] DID Table
Programming Manual References
12.4 [10-3] DID Table—Automatic Registration
Feature Manual References
4.1.6 DID (Direct Inward Dialing)
DID Name
Specifies the name for the DID number which is shown on the extension's display when receiving a call with
the DID number. The name of the DID number can be printed out on SMDR.
Default
Not stored.
Value Range
Max. 20 characters
Maintenance Console Location
12.3 [10-3] DID Table
Document Version 2011-10
12.3 [10-3] DID Table
PC Programming Manual 853