Panasonic KX-TDA100 Features Manual page 172

1.22 Portable Station (PS) Features
Conditions
• Whether or not a PS is allowed to pair itself with a wired telephone is determined by the COS assigned
to the extension number of the wired telephone. (→ Wireless XDP Parallel Mode for Paired Telephone
[515])
• Wireless XDP Parallel mode can be turned on or off using the PS only.
• To switch between the wired telephone and the PS during a conversation, simply go off-hook with the
other telephone. Alternatively, to seize a separate line, use another method, such as pressing a CO or
INTERCOM button.
In addition, going off-hook with the other telephone seizes a separate line when the extension is:
a)
Engaged in a conference call. (→ 1.13.1 Conference Features)
b)
Screening a call using Live Call Screening (LCS) or when recording a conversation using Two-way
Record. (→ 1.21.2 Voice Mail DPT (Digital) Integration)
c)
Receiving an Off-hook Call Announcement (OHCA). (→ 1.7.4.3 Off-hook Call Announcement
(OHCA))
d)
Being monitored by another extension. (→ 1.7.3 Call Monitor)
e)
When the extension has a call on consultation hold. (→ 1.12.5 Consultation Hold)
• When a PS in Wireless XDP Parallel mode is on a call, other extension users cannot perform the
following features when they call this extension:
– Executive Busy Override
– Whisper OHCA (→ 1.7.4.4 Whisper OHCA)
• When a PS is paired with a wired telephone, most of the extension settings assigned to the wired
telephone (extension number, extension name, etc.) will be used by the PS, and the PS will use its own
extension settings once again when Wireless XDP Parallel mode is canceled. Note, however, that the
following extension settings of the wired telephone are copied to the extension settings of the PS when
Wireless XDP Parallel mode is activated, and will remain in effect for the PS after the mode is canceled.
– Call Waiting Setting (→ 1.1.3.3 Call Waiting)
– FWD/Do Not Disturb (DND) Setting (→ 1.3.1 Call Forwarding (FWD)/Do Not Disturb (DND))
– Call Pickup Deny Setting (→ 1.4.1.3 Call Pickup)
– Executive Busy Override Deny Setting
– Itemized Billing Code for Automatic Route Selection (ARS) (→ 1.9.1 Automatic Route Selection
(ARS))
– Calling Line Identification Presentation (CLIP) Number (→ CLIP Number [606])
– CLIP Number Selection
– Calling Line Identification Restriction (CLIR) Setting
– Connected Line Identification Restriction (COLR) Setting
– Extension Personal Identification Number (PIN) (→ Extension Personal Identification Number
(PIN) [005]) (→ 1.25.1 Extension Personal Identification Number (PIN))
– COS Programming (→ Class of Service [602]) (→ 2.2.1 Class of Service (COS))
– Extension Group (→ Extension Group [603]) (→ 2.2.2 Group)
– Transfer Recall Destination for Call Transfer and Call Park
• The PS will retain its original settings for the following items even when in Wireless XDP Parallel mode.
These settings can be set on the wired telephone and PS independently, and the settings can be
different.
– Ring Tone Pattern Table Selection (→ 1.1.3.2 Ring Tone Pattern Selection)
– Preferred Line Assignment—Incoming (→ 1.4.1.2 Line Preference—Incoming)
– Preferred Line Assignment—Outgoing (→ 1.5.5.2 Line Preference—Outgoing)
– Hot Line Setting (→ 1.6.1.6 Hot Line)
172 Feature Guide