A
•
Turn the Portable Station off and back on again, to force it to re-register its location.
Q
I changed the FCO of a Portable Station, but the display of the Portable Station
still shows the old FCO.
A
•
Turn the Portable Station off and back on again, to force it to re-register its location.
Q
If I delete the extension number of a Portable Station, and then turn the
Portable Station off and back on again, it does not function correctly.
A
•
Do not delete the extension number of the Portable Station.
Q
How do I prevent extension numbers being automatically assigned to a newly
installed card?
A
•
Change Extension Number Set Mode in the Configuration—Option screen (see
"4.7.16 Option [1-4]") from Automatic to Manual.
Q
How do I prevent newly installed cards automatically being changed to "INS"?
A
•
Change Status after Card Install in the Configuration—Option screen (see "4.7.16
Option [1-4]") from "In Service (INS)" to "Out of Service (OUS)".
Q
I cannot change an LCO port to INS status.
A
•
Is the card installed in the appropriate slot?
•
Is the card installed in the correct slot, but not functioning correctly?
Check the condition of the card.
•
Is the card itself in INS status?
Set it to INS status.
•
Is a CO line connected to the appropriate port?
•
Is the port in FAULT status, even though a CO line is connected?
Run diagnosis on the relevant slot.
Q
How do I change the dialing mode of an analog CO line?
A
•
From the Configuration—LCO Port screen (see "4.7.17 LCO Port [1-5]"), change the
Dialing Mode setting of the target port to "DTMF" or "Pulse", as required.
How do I set disconnect detection (CPC Detection) for an analog CO line?
Q
A
•
From the Configuration—LCO Port screen (see "4.7.17 LCO Port [1-5]"), modify the
CPC Signal Detection Time—Outgoing, Incoming setting of the target port.
The required value varies by carrier. Transmission and reception can be set separately.
How do I connect to another PBX using QSIG?
Q
A
•
From the Configuration—PRI Port (see "4.7.19 PRI Port [1-6]") screen, set the Port
Type of the port you want to use to either "QSIG-Slave" or "QSIG-Master".
Q
I cannot open the subwindow for a certain card.
A
•
First, either install the card, or set the status of a slot to "Pre-Install".
Q
How do I change the extension number of a wired extension?
4.6 Help
Feature Guide
337