Utility-File Transfer Pc To Pbx (Sd Card) - Panasonic KX-TDA100 Features Manual

4.5 Utility
DTMF detection (CO—>Ext)
DP detection (CO—>Ext)
BELL detection (Ext—>CO)
Speech path (Ext—>CO)
Speech path (CO—>Ext)
To perform a pair port test
1.
From the Utility menu, select Diagnosis.
2.
Click on the Status cell of the extension card to be tested, and set it to "OUS".
3.
Click on the cell showing the card type.
A new window will be displayed.
4.
Select the Pair Port Test option.
A new window will be displayed. The card you selected in Step 3 will be shown in the Extension Line
Slot No. drop-down list.
5.
From the CO Line Slot No. drop-down list, select the slot number of the CO line card you want to test.
6.
From the CO Line Port No. drop-down list, select the port number of the CO line you want to test.
7.
Click OK.
The error report will be displayed.
8.
Select an option:
• Click Capture if you want to save the displayed information.
1.
Enter a file name, or select a file to overwrite.
2.
Click Save.
• Click Cancel to return to the Diagnosis screen.
4.5.2 Utility—File Transfer PC to PBX (SD Card)
Copies PBX system files (program files and data files) from the connected PC to the SD memory card
installed in the PBX. Pre-existing files on the SD memory card are overwritten.
This option is only available at Installer level.
2 types of files can be copied using this tool:
• Program files: These contain the programs used to operate cards within the PBX and CSs, acting
as on-board drivers.
• Data files: These contain the initial configuration data for individual cards and settings.
Not all files that are copied using this tool are automatically made active. To install new program files or main
system data to the PBX, use the System Reset—Reset by the Command utility (see "4.5.17 Utility—System
Reset—Reset by the Command") for PMPR and DSYS files, and the SD Card File View and Load utility
(see "4.5.4 Utility—SD Card File View and Load") for all other files.
The PBX examines the header information of a file to determine 2 things: whether the file contains
supported data, and which system component the file applies to.
Only files whose header information matches that of a system file supported by the PBX can be transferred.
Attempting to transfer any other type of file results in an error message.
320 Feature Guide
DTMF generation/detection from CO line to extension
DP generation/detection from CO line to extension
BELL generation/detection from extension to CO line
Speech path from extension to CO line
Speech path from CO line to extension