Epson StylusPro 10000 Service Manual page 286

EPSON Stylus Pro 10000/10000CF
3.2 Cutter : Confirm the cutter solenoid actuation with manually pushing. (Refer to 4.2.3.4)
o
Removing the cutter edge, then confirm whether the edge of blade gets dirty and
also the piece of paper etc. be not adhering.
o
Does the cutter solenoid work smoothly?
o
Confirm whether pushes against the cutter solenoid and the edge of a blade be
locatedding to the ditch of paper guide L2. (Slowly moving the carriage right and
left it confirms in both ends. Gap with the ditch be the range of 0.3 - 0.7 mm)
3.3 CR motor / Steel belt : Confirm the carriage actuation with manually moving.
o
While seeing the CR driven pulley moving the carriage that the steel belt always is
at the center of a pulley is confirmed. Even that there are not dirt and abrasion in
the steel belt and pulley confirms.
o
Is there looseness in 2 screw that are fixing the steel belt to the carriage?
Maintenance
Figure 6-16.
Figure 6-17.
o
Is there looseness in the set screw of the bearing stopper that is attached to the CR
motor?
Bearing stopper
4. Forms tractor
4.1 PF motor : Confirm the PF motor actuation with manually revolving. (Refer to 4.2.3.10)
o
Are there abrasion and looseness in the belt between the PF motor and slowing-
down gear?
o
Is there abrasion in the gear (aluminum) that is attached to the PF motor axis?
PF motor axis / gear
Maintenance inspection items
Steel belt
Figure 6-18.
CR driven pulley
Figure 6-19.
Revision A
CR driven pulley
Steel belt
Loop scale
Slowing-down gear
286