Selectype Settings - Epson StylusPro 10000 Service Manual

EPSON Stylus Pro 10000/10000CF
Table 1-27. Operating Panel Messages (continued)
Display Message
INK LOW
MAINTENANCE REQ. nnnn
PRINTING *
PAPER OUT
Notes*:Only when PG setting = WIDE, 20th character is "H" on LCD.
Product Description
Meaning
When total dots fired = 90%, cartridge enters near-end
condition. Remaining ink = A1 at 100% duty
Printer requires maintenance - see "Maintenance
Request" on page 49
Processing print data.
• No paper loaded
• End of roll paper (printer stops feeding)
• End of sheet paper (when paper feeds to eject
position, put hand under the sheet and press Cut/
Eject to release)

1.6 SelecType Settings

o
Entering SelecType mode
To access the operating Panel settings, press the SelecType button while the printer is not
printing. The printer enters the SelecType mode and cannot print.
o
Using SelecType mode
1. Repeatedly press the SelecType button to view the SelecType menus which appear in
the order shown below.
Display Message
PRINTER SETTING MENU
TEST PRINT MENU
PRINTER STATUS MENU
PAPER CONFIG. MENU
CUTTER REPLACE MENU
HEAD ALIGNMENT MENU
2. Press the Item button to select the choice shown in the LCD display.
3. Press the SelecType button to view the options for that Item.
4. Press the "+" button or "-" button to view the available values for an option.
5. Press the Enter button to record the current option or to execute the operation shown in
the display.
SelecType Settings
Table 1-28. SelecType Menus
For details
Printer Setting Menu
Test Print Menu
Printer Status Menu
Paper Configuration Settings
Cutter Replacement Menu
Head Alignment Menu
Revision B
42