Cutter Replacement Menu - Epson StylusPro 10000 Service Manual

EPSON Stylus Pro 10000/10000CF
5. Press Item and confirm that "THICK. PAT. = Print" appears on the display. Then press
Enter to print the paper thickness pattern.
Figure 1-10. Paper Thickness Detection Pattern
6. Select the number of the most vertically aligned pair of lines, and press Enter. (#5 is
correct in the example below).
If necessary, select Drying Time from the Paper Config menu to select an automatic period
of time that the printer will pause printing to let the previously printed sheet dry. Also, to
prevent thin or light paper from getting stuck over the paper suction holes in the Lower
Paper Guide, you can select Low (50% power) as the Suction setting.
Product Description

1.6.5 Cutter Replacement Menu

Print the Status Sheet from the Test Print menu in SelecType mode and see page 45 for
information on determining when the cutter needs to be replaced.
The following table includes the steps/messages that must be followed to replace the cutter.
Items
Replace cutter
Cover open guide
Cutter replacement guide
Cover close guide
If you need to replace the cutter:
1. Select the cutter replacement menus from the panel.
*The cutter replacement menu can be selected with pushing SelecType button for 5
sec.
2. Open the cover on the guide.
3. Replace the cutter blade following the guide.
4. Close the cover on the guide.
SelecType Settings
Table 1-33. Cutter Replace Menu
LCD panel display
CUT. REPLACE
OPEN LOWER COVER
REPLACE CUTTER
CLOSE LOWER COVER
Revision B
Values
EXEC.
-
-
-
48