Removing The Housing; Panel Unit Removal - Epson StylusPro 10000 Service Manual

EPSON Stylus Pro 10000/10000CF

4.2.1 Removing the Housing

This sections describes the removal procedure for printer housing parts. See below for an
illustration of the housing parts.
Roll Paper Cover
(Front View)
Paper Guide L2
Front Cover Paper Set Lever
(Rear View)
Interface Cover
Waste Ink Cover
Figure 4-3. Housing Part Diagram
Disassembly & assembly
H Top Cover R Side Cover
Panel Unit
IC Holder Cover
Paper Guide U
Rear Cover

4.2.1.1 Panel Unit Removal

1. Push the clips (Refer to Figure 4-5. ) on both sides of the panel unit and pull slightly
away from the R Side Cover.
Push it toward you.
Figure 4-4. Panel Unit Removal 1/2
Lift it up
2
Disassembly Flow
1
3 Lift it up then turn over.
3
Clip
Figure 4-5.
Revision A
Clips
Connector
120