Epson StylusPro 10000 Service Manual page 95

EPSON Stylus Pro 10000/10000CF
Table 3-10. Different paper source is selected on panel
Item
LCD message LOAD xxxx PAPER
• "PAPER OUT" LED goes on.
LED indicator
• The LED blinks corresponding to paper path set with PP command of
status
remote command as following table;
Roll paper and cut sheet size settings differ.
The PP remote command determines the paper path, and when this setting
Explanation
and the paper setting made via the control panel differ, this (paper mismatch)
error occurs.
Load the correct paper size, or change the setting in the control panel/driver
Recovery to match the size of the paper loaded in the printer. When this error clears,
printing begins.
Table 3-11. Paper Path Command and LED Indicators
Roll
PP Command
Auto Cut
Roll Paper Blink
Cut Sheets Off
Table 3-12. Paper set lever is released (During paper set position)
Item
LCD message LOAD PAPER
LED indicator
"PAPER OUT" LED goes on.
status
Explanation The Paper Set Lever is in the release position during paper set operation.
Push down the lever after paper setting, the error clears. Then "PRESS
Recovery
PAUSE BUTTON" will appear and press PAUSE button to start printing.
Troubleshooting
Description
Roll
Sheet
No Cut
Blink Off
Off Blink
Description
Troubleshooting Using the Messages
Table 3-13. Paper jam
Item
LCD message PAPER JAM
LED indicator
"PAPER OUT" LED blinks.
status
• Paper jam is detected if the both of rear and front paper sensor detects
paper existing.
Explanation
• Over drive current or mis-synchronization of CR motor is detect.
After removing the jammed paper, "TURN PWR OFF AND ON" is
Recovery
displayed and then reboot by turning off and on.
Table 3-14. Cover open
Item
LCD message COVER OPEN
LED indicator
N/A
status
The front cover is open.When this error is occurs, the carriage movement
Explanation and ink sequence are held. Therefore it may give damages to printing head if
this situation continues very long time.
Close the front cover.
• If it occurs during printing, it recover to print ready status
Recovery automaticaly.But, the suspended printing pass is never resumed.
Therefore, there may appear a stripe on the print out.
• If it occurs during pause status, it recover to pause status automatically.
Revision B
Description
Description
95