Epson StylusPro 10000 Service Manual page 37

EPSON Stylus Pro 10000/10000CF
INITIALIZATION
There are three kinds of initialization method.
1. Power-on initialization
This printer is initialized when turning the printer power on.
When printer is initialized, following action is performed.
(a) Initializes printer mechanism.
(b) Clears input data buffer.
(c) Clears print buffer.
(d) Sets default values.
2. Software initialization
The ESC @ command also initializes the printer.
When printer is initialized, following action is performed.
(a) Clears print buffer.
(b) Sets default values.
3. Panel initialization
This printer is initialized when pushing the Pause button more than 3 seconds, or
printer recognized the -INIT signal.
When printer is initialized, following action is performed.
(a) Eject a paper. (If roll paper, it cuts paper skipping print part when Paper Source =
Auto Cut, it doesn't cut when Paper Source = Cutter Off with SelecType)
(b) Cap the print head.
(c) Clears input data buffer.
(d) Clears print buffer.
(e) Sets default values.
DEFAULT SETUP VALUES
Default setup values are as follows. The parameters for items which may be saved for panel
setup, default setup, and remote commands are used as default values.
Page position : Current paper position as page start position
Line feed : 1/6"
Right margin : 437th character
Product Description
Left margin :
Character pitch :
Print mode :
Interfaces
1st character
10 CPI
Text mode (non-raster graphics mode)
Revision B
37