Epson StylusPro 10000 Service Manual page 172

EPSON Stylus Pro 10000/10000CF
5. Disconnect the cable for the panel unit from the cable clump on the Dot missing
detector.
Cable for the panel
unit
Dot missing
detector
Figure 4-136.
6. Hold the Dot missing detector with your hand then remove the two screws (
:M4x8) securing the Dot missing detector to the CR guide rail, then remove the Dot
missing detector.
CR Guide rail
Screw
Figure 4-137.
Disassembly & assembly
Cable clump
Disassembly Flow
When secure the screw, pay attention so as not to drop the screw into
the CR guide rail by using the magnet driver. (It is because be not
seen the place when the screw is dropped into the CR guide rail.)
Do not scar the steel belt.
Revision A
172