Removing The Suction Control Motor; Removing The Ink Pump Assy - Epson StylusPro 10000 Service Manual

EPSON Stylus Pro 10000/10000CF

4.2.3.14 Removing the Suction Control Motor

1. Disconnect the cable connector connected to CN14 on the C362DRV board.
Suction control
motor
Figure 4-138.
2. Marking the suction control motor fixing position.
3. Remove two screws fixing the suction control motor, then remove it.
Suction control
motor
Figure 4-139.
Disassembly & assembly

4.2.3.15 Removing the Ink Pump ASSY

1. Remove the Cleaning Unit as described in "Removing the Cleaning Unit" ("Removing
the Cleaning Unit 167.)
Cables
2. Disconnect the cables for the ink release plunger and Ink Pump Motor from its
(connected to CN14
connector CN11 / 25 on the main board, and take the cable out from the hole in the R
on the C362DRV
side frame.
board)
3. Disconnect the cable from sensor connector.
Ink motor cable
Ink pump motor
Screw
Disassembly Flow
Dot missing
detector
Figure 4-140.
Revision A
Air release
plunger cable
173