Cutter Position Adjustment - Epson StylusPro 10000 Service Manual

EPSON Stylus Pro 10000/10000CF

5.2.3.4 Cutter position adjustment

At the power off condition, prepares the A4 size or similar paper and ensure the cut action
carried out normally on the side of a starting point side and opposite side.
Gap between the blade and Sub_Platen should be 0.3 to 0.7 mm.
<Adjustment procedure>
1. Select the "Test: Sensor" from the diagnostic mode and release the capping.
2. Open the front cover and loosen the all Sub_Platen fixing screws. Then push it to
toward the bottom.
3. At the starting point side, loosen the two of cutter holder screws then mount the L type
adjusting tool on the Sub_Platen. Fix the cutter holder position after the adjustment of
gap to the Sub_Platen.
4. Attaching the adjustment tool from the right side and perform the adjustment with
Sub_Platen fixing screw.(6 Sub_Platens are presented.)
5. Confirm the cutter operation by pressing the cutter cap several times.
6. Shut the front cover and escape from "Test: Sensor" mode. (At this time place the
carriage in the middle of CR rail way.)
7. Turn on the printer power and implement and confirm the paper cut operation.
Adjustment
L Type adjusting tool
Figure 5-5.
Do not take the up-and-down motion of the cutter in the place other
than the Sub_planten area.(It will cause cutter blade damage.)
Adjustment Steps
Revision B
198