Epson StylusPro 10000 Service Manual page 145

EPSON Stylus Pro 10000/10000CF
5. Remove the Waste Ink Box by sliding it forward so the hooks on both sides release and
then pull up.
Figure 4-67. Waste Ink Box
6. Remove three screws on the ink tube clamp and remove it.
Ink tube clamp
Screw
Figure 4-68. Disassembly of the Waste Ink Box
7. Remove the old Waste Ink Unit and dispose of them properly.
Disassembly & assembly
Waste Ink Unit
Disassembly Flow
When replacing the Waste Ink Unit, prepare a vinyl bag beforehand
for disposal of the Pads.
8. Insert new Waste Ink Unit, and re-install the Waste Ink Box in the printer.
When replacing the Waste Ink Unit, the following adjustment
procedures are required. See "Maintenance Mode 2" on page 50.
n
INIT. WASTE INK
n
INIT. CLEANING
To reassemble the waste ink box and related parts, follow the above
steps in reverse order and make sure you keep the following in mind:
n
The waste ink tubes should be inserted into the ink tube clamp.
n
Make sure the tubes are not twisted or pinched.
(Front side view)
Connect to the flushing box.
Connect to the Creaning unit.
Figure 4-69.
Revision A
145