Epson StylusPro 10000 Service Manual page 97

EPSON Stylus Pro 10000/10000CF
Table 3-19. Replace ink cartridge
Item
LCD message INK COMPART. OPEN
LED indicator
N/A
status
Explanation Ink holder is open.
Close the holder cover.
• If it occurs in "PRINTING" or "READY" status, it return to
Recovery
"READY" status.
• If it occurs in "PAUSE" status, it returns to "PAUSE" status.
Table 3-20. Ink end
Item
LCD message INK OUT
LED indicator
Corresponded "INK OUT" LED goes on.
status
Ink end error occurs when ink cartridge and sub tank reached ink end
Explanation
level.
Recovery Set new ink cartridge.
Table 3-21. No ink cartridge
Item
LCD message NO INK CARTRIDGE
LED indicator status Corresponded "INK OUT" LED goes on.
Explanation The ink cartridge is not set completely in the cartridge holder.
Recovery Set ink cartridge completely.
Troubleshooting
Description
Description
Description
Troubleshooting Using the Messages
Table 3-22. Type-B interface error
Item
LCD message OPTIONAL I/F ERROR
LED indicator status N/A
An unsupported optional interface card is installed but cannot be
Explanation
used.
Turn off the printer, remove the unsupported option card, and
Recovery turn the printer back on. Install a supported option card if
necessary.
Table 3-23. Cannot test print
Item
LCD message Cannot Print
LED indicator status Same as before this error arose.
Cannot perform test print.
Due to one or more of the following reasons the printer cannot
print a nozzle check pattern, status sheet, PG adjustment pattern,
or paper thickness pattern:
1) No paper loaded
Explanation
2) Ink cartridge missing
3) Paper recognition error
This error appears on the LCD panel for about three seconds, and
then the display returns to its previous state.
Exit SelecType mode and clear the error that appears on the
Recovery
LCD panel. Then return to SelecType mode and print.
Revision B
Description
Description
97