Warnings - Epson StylusPro 10000 Service Manual

EPSON Stylus Pro 10000/10000CF

3.2.1 Warnings

Warning messages appear on the LCD display to warn users that a problem may occur. The
printer can still print and there is no effect on print quality; however the messages do not go
away until the possible problem is taken care of or the printer enters the corresponding error
condition. For example, the Waste Ink Pads Near Full message will remain until the pads
are replaced and the counter is reset or until the pads become full and the printer enters an
error state.
Table 3-4. Ink Low
Item
LCD message Ink Low
LED indicator
The LED indicator for the ink cartridge that is low flashes.
status
The printer has received the Near-End signal from one of the ink low
sensors. After the LCD displays the Ink Low warning, the printer can print
about one A1 sheet at 100% duty. By all means, change the ink cartridge as
soon as possible.
Explanation
Once a "low-ink" cartridge has been removed, it will automatically cause an
ink-end error if replaced in the printer.
Only replace empty or low cartridges with new, full cartridges; otherwise the
ink counter cannot perform correctly.
Recovery Replace the old ink cartridge with a new one.
Troubleshooting
Description
Troubleshooting Using the Messages
Table 3-5. Ink End
Item
LCD message INK OUT
LED indicator
Corresponded INK OUT LED blinks
status
The printer detects ink end from an ink cartridge. It can print B0 (duty
Explanation 100%) with sub tank ink cartridge just after this status, however, replace the
cartridge with a quite new one as soon as possible.
Recovery Replace the ink cartridge with new one.
Table 3-6. Ink Cover Open
Item
LCD message CLOSE INK CART. COVER
LED indicator
All color ink cartridge LEDs go on.
status
Explanation It is occurred when ink cartridge cover is open during printings.
Recovery Close the ink cartridge cover.
Table 3-7. Maintenance Request
Item
"MAINTENANCE REQ. nnnn"
LCD message
"nnnn": Refer to "Maintenance call" on page 101
LED indicator
Paper Out LED goes on for 100ms at intervals of 5 seconds.
status
The life of the unit which designated by the code "nnnn" is almost run out. It
Explanation
prompts user to call the service person to maintain it.
Recovery Refer to "Maintenance call" on page 101.
Revision B
Description
Description
Description
93