Download Print this page

Advertisement

Unpacking
and Assembly Guide
Copyright ©2001 by SEIKO EPSON CORPORATION, Nagano, Japan
XXXXXXX-XX
XXX-00

Advertisement

   Related Manuals for Epson stylus pro 10000

   Summary of Contents for Epson stylus pro 10000

  • Page 1

    Unpacking and Assembly Guide XXXXXXX-XX Copyright ©2001 by SEIKO EPSON CORPORATION, Nagano, Japan XXX-00...

  • Page 3: Table Of Contents

    Contents Choosing a Place for the Printer........2 Deciding Where to Unpack the Printer .

  • Page 4: Choosing A Place For The Printer

    English Important: Avoid locations near TVs, radios, air conditioners, or humidifiers. To avoid damage to the unit, read this manual and follow the instructions Avoid locations that are subject to shocks or carefully. vibrations. Keep the printer away from combustible substances.

  • Page 5

    Parts: Tools: Hex wrench Hex socket head bolt, M6 × 30 (8) Wing nuts (2) J is for connecting the printer unit to the base unit. Base upright, left Base upright, right Horizontal struts (2) Basket hooks, long (2) Basket hooks, short (2) Stanchion pins (2) Paper basket...

  • Page 6: Assembling The Base Unit

    Assembling the base unit Assembling the Printer Caution: Have two people working on either side to assemble the base unit (26 kg). Unpacking the printer unit 1. Hold base upright left (A) and a horizontal Caution: strut as shown. Then fix the strut to the base The printer unit is heavy and unwieldy.

  • Page 7: Checking The Printer Unit Box Contents

    3. Take out the cardboard panels from around the printer. Printer unit Roll paper spindles Roll paper (EPSON Semigloss Photo Paper; 5 m) Roll paper belts (for keeping roll paper wound up) Ink cartridges (Yellow, Cyan, Magenta, Light Cyan, Light Magenta, Black)

  • Page 8

    2. Lock the two casters (A) and extend the two stabilizer knobs (B) underneath the base unit. top view 4. Screw the two wing nuts (C) into the left and right joint holes at the side-inner of the base unit, and tighten them. 3.

  • Page 9: Attaching The Paper Basket

    Attaching the paper basket 4. Turning the stitch side downward, spread the paper basket on the floor. 1. Insert the stanchion pins (G) to the hole on the the base uprights backward. 5. Holding the rear side shaft, pass it under the horizontal struts and insert the both joint 2.

  • Page 10: Connecting The Power Cord

    Connecting the power cord 7. Hook the both ends of the center shafts (I) on the upper basket hooks. 1. Connect the power cord to the AC inlet on the back of the printer. 8. Hold the front side shafts (J) and turn it one revolution as shown below.

  • Page 12

    Printed in Japan 00.xx-xx...

This manual also for:

Stylus 10000cf

Comments to this Manuals

Symbols: 0
Latest comments: