Epson StylusPro 10000 Service Manual page 204

EPSON Stylus Pro 10000/10000CF
NOTE: If the lightest pattern judgement is difficult, regard the opposite side of
home position.
10. Enter the "Maintenance mode " and input the value to the "XX1 to XX4".
1. Refer to the Table 5-7/Table 5-8 and confirm the panel input value with used paper
type.
2. Select the panel input group(XX1 to XX$) and display the specified paper panel
input message as shown following figure.
Panel input group
(XX1-XX4)
3. Enter the correction address which are shown on the table 5-6/5-7.(Select the
address value by pressing paper feed +/- button.)
4. Press Cleaning button.
5. Enter the value to the Initial value.
6. Press the Enter button.
11. Turn off the printer power.
n
This adjustment is needed in only Bi-D printing.
n
This adjustment is needed for the paper types on following tables
only.
Adjustment
*
*
Correction Initial value
address
(correction value)
Figure 5-14.
Adjustment Steps
Revision B
204