Rear Sensor Position - Epson StylusPro 10000 Service Manual

EPSON Stylus Pro 10000/10000CF

5.3.4.14 Rear sensor position

This adjustment to detect the form length of cut paper precisely. The position of rear sensor
inside firmware is adjusted on the basis of the nozzle to secure the maximum Pause range
from the paper edge. Set the A3 cut sheet paper in direction of side put and cause a
horizontal line (1 of dot line of black) printing in the place of 14 mm from the paper edge
and measure the length of it from edge then input the value revision. This adjustment is not
necessary at the field even if band correction is performed, although this item is necessary
in a production process. Cut sheet is required without the condition of cut sheet placement
when this item is selected.Figure 5-70 showing menu sequence and figure 5-71 showing
print pattern.
Please Set Cut Sheet
Enter
Printing Pattern
Paper Width xxx.xmm
Rear Sen. Pos. : xx.xmm
o
Measure the length between the paper edge to printed line and input the rear sensor
position.
Adjustment
Eject the sheet after the printing.
Shift to the "RearSen.Pos.:xxmm"
with "Pause" key.
Adjust the position with unit 0.1mm
by "Paper feed+/-" key.
Figure 5-74.
Shift to the "Test print" by pressing "Enter" key during the "Rear sensor" display.
Self-Diagnostics
Rear sensor position
correction
Paper Feed
Figure 5-75.
Revision B
248