Removing The Cutter And Cutter Unit - Epson StylusPro 10000 Service Manual

EPSON Stylus Pro 10000/10000CF

4.2.3.4 Removing the Cutter and Cutter unit

1. Remove the two screws (CP(W):M3x6) securing the carriage cover and remove the
carriage cover.
Cutter
Carridge cover
Figure 4-100.
NOTE:
n
When remove the cutter blade, take the following steps 2 to 3.
n
When remove the cutter unit, take the following steps 4.
Disassembly & assembly
Screw
2. Push down and hold the cutter lever then pull up the solenoid and rotate it to the arrow
direction.
Cutter lever
3. Pulling up the cutter from cutter unit.
Run the automatic cutting operation, after cutter unit attaches. The
cutter is released to the home position and cut it the form accurately.
Disassembly Flow
Solenoid
Figure 4-101.
Cutter
Figure 4-102.
Revision A
158