Epson StylusPro 10000 Service Manual page 281

EPSON Stylus Pro 10000/10000CF
Table 6-3. Status sheet
Item Panel display
Ink remainder quantity (K) INK LEFT(K)
Ink remainder quantity (C) INK LEFT(C)
Ink remainder quantity (M) INK LEFT(M)
Ink remainder quantity (LC) INK LEFT(LC)
Ink remainder quantity (LM) INK LEFT(LM)
Ink remainder quantity (Y) INK LEFT(Y)
Cutter life CUTTER LIFE
Total printing number of sheets TOTAL COUNT
Waste ink counting WASTE INK
CR motor life monitor CR MOTOR
PF motor life monitor PF MOTOR
Head unit life monitor HEAD UNIT
CLEANING
Cleaning unit life monitor
UNIT
Maintenance
Setting value Contents
The remainder quantity of the
ink is displayed every the ink.
C : Cyan
E*****F
M : Magenta
(*1)
LC : Light cyan
LM : Light magenta
Y : Yellow
K: Black
The life of the cutter is
displayed.
Cutter life be about 2000 sheets.
E*****F
(However in the case of film
(*1) system form, about 1000 sheets.)
The life information of the cutter
is reference. Actually, judge
from the piece condition.
nnnnnnn (Max 6 The number of sheets that
columns) printed it is displayed.
This item is the maintenance
information that the service
engineer uses the maintenance
for the purpose.
E*****F
[Maintenance call 100] with
(*1)
the remainder quantity of 3%
[Service call 000100] with
the remainder quantity of 0%
General Maintenance Issues
*1 : The meaning of the command of the ink remainder quantity and cutter life are as
follows. Refer to 4.2.1.2.
Display Remainder quantity of the ink
E*****F Ink full condition (Full)
E**** F
E*** F
E** F
E* F
E F
Ink remainder quantity is little (The
ink end lamp blinking)
NN%
Ink low condition (10% or less of
the remainder quantity)
Ink end (The ink out indicator
0%
comes on)
n
Do not carry out the counter initialization without necessary part
exchange/inspection, although the counter initialize is possible
with "the counter initialization menu" of "maintenance mode 2".
(Especially, do not clear the counter of "Waste ink", "Ink
remainder quantity" to the unpreparedness, to exert the
influence on the product actuation.)
Revision A
Table 6-4.
Life of the cutter
There is a remainder life (Full)
Remainder life is little.
End
* The life of the cutter is rough
standard. When the cutter is
exchanged, display becomes full
condition.
281