Mechanism Adjustment - Epson StylusPro 10000 Service Manual

EPSON Stylus Pro 10000/10000CF
n
Even If the updating processing has discontinued halfway
(because of power off /etc.) with both method, it is recoverable
with same operation again.
n
The backup card you use in these steps only works with the
Stylus Pro 10000/10000CF; do not attempt to use it with other
printers.
Adjustment

5.2.3 Mechanism Adjustment

This section describes the adjustment procedures necessary after replacing certain
parts.Following table showing certain adjustment items.
certain parts
CR Motor CR steal belt tension
PF Motor PF timing belt tension
Self diagnostics/ "Paper
P-Thick sensor
Thickness"
Cutter Sub Platen position
Front cover Cover sensor position
Slide Motor Gear backrush
CR Encoder Encoder position
Print Head Print head slant
Dot missing detector Offset adjustment
Front sensor Paper Detect position
Rear sensor Paper Detect position
P_Edge sensor Paper Detect position
paper feeding
adjustment
Cutter pressure Cutter pressure
Do not loosen the screw on the print head department as shown figure 5-1.
Adjustment Steps
Table 5-3.
Adjustment item Required tool
Tension gauge/1054053
Tension gauge/B747700300
Adjustment tool/1070178
Adjustment tool/1070171
Kimoto #300 tracing paper
Tension Gauge #F712
Revision B
Reference
page 195
page 197
page 197
page 198
page 199
page 199
page 200
page 200
page 201
page 201
page 201
page 201
page 203
page 206
194