Removing The I/C Holder Cover Sensor Assy - Epson StylusPro 10000 Service Manual

EPSON Stylus Pro 10000/10000CF
2. Remove two screws (Mx8) securing Front Cover Sensor R.
Figure 4-169.
3. Disconnect the cable connector CN5 on the C362DRV board.
Perform the necessary adjustment listed in Chapter 5. This
adjustment is required to make the Cover Sensor ASSY work
interlocking with the close/open status of the Front Cover.
Disassembly & assembly
Screw

4.2.3.25 Removing the I/C Holder Cover Sensor ASSY

1. Remove the R side Cover as described in "R Side Cover Removal 124.
2. Remove the I/C Holder Cover as described in "I/C Holder Cover Removal 125.
3. Disconnect the cable connector from the CN1 on the CSIC board, then remove from
two clamps.
Clump
4. Remove two screws on the I/C holder cover sensor, then remove it.
Screw
Disassembly Flow
CSIC board
I/C holder cover sensor
Figure 4-170.
I/C holder cover sensor
Figure 4-171.
Revision A
CN1
184