Epson StylusPro 10000 Service Manual page 105

EPSON Stylus Pro 10000/10000CF
SERVICE REQ. 00010007: CR MOTOR IN POSITION TIME OUT
o
Problem
When be it locateds stable at the time of halt processing with the CR motor
control, (the in position time) the position control inside period did not improve.
o
Solution
n
Tension adjustment of the n steel belt
n
CR encoder exchange
n
CR motor exchange
n
C362DRV board exchange
SERVICE REQ. 00010008: SERVO INTERRUPTION WATCH DOG
TIME OUT ERROR
o
Solution
n
C362DRV board exchange
n
C362MAIN board exchange
SERVICE REQ. 00010009: SYSTEM INTERRUPTION WATCH DOG
TIME OUT ERROR
Not supported.
SERVICE REQ. 0001000A: CR ORIGIN (HOME POSITION) SENSOR
MULFANCTION
o
Problem
The carriage (CR_) HP detection sensor is abnormal.
o
Solution
n
Cleaning of the CR_HP detection sensor
n
Whether or not CR_HP detection sensor cable is jointed to the C362DRV board
(CN43) confirmation CR_HP detection sensor exchange
n
CR_HP sensor exchange
n
C362DRV board exchange
Troubleshooting
SERVICE REQ. 0001000B: PF ORIGIN (HOME POSITION) SENSOR
MULFANCTION
Not supported.
SERVICE REQ. 0001000C: HS ORIGIN (HEAD SLIDE HOME
POSITION ) SENSORS MALFUNCTION
o
Problem
n
Head SLID starting point sensor failure
n
Sensor is in trouble.
n
Head slide motor, motor connector or cable is in trouble.
n
Gears are not engaged.
o
Solution
It confirms whether the detection actuation such as the adhesion, dirt of ink are
prevented in the sensor surface and be abnormal no and check the SLID starting
point sensor, in the case that the error is not canceled.
In the case that there is abnormality:
n
Cleaning of the SLID starting point detection sensor
n
Head SLID starting point detection sensor cable be confirmation whether or not it
is jointed to the C362DRV board (CN52).
n
Head SLID starting point detection sensor exchange
n
C362DRV board exchange
Service engineer require message
Revision B
105