Epson StylusPro 10000 Service Manual page 234

EPSON Stylus Pro 10000/10000CF
PIGMENT INK
Mode for the head selection of pigment ink code
Following figure showing head number selection menu sequence.
Item
Input Head 1 Code
SelecType
Item
Input Head 2 Code
SelecType
Item
Input Head 3 Code
SelecType
Adjustment
Press the [Enter] key to select
the input mode of Head 1.
Press the [Enter] key to select
the input mode of Head 2.
Press the [Enter] key to select
the input mode of Head 3.
Figure 5-49.
o
Cord input for pigment
Mode for the head code input. Cursor is appeared under the input column.
Following figure showing menu sequence.
Head 1-3 X R \ \ \ \
Head 1-3 X R \ \ \ \
Head 1-3 X R \ \ \ \
Enter
End with "Pause" key.
Wait
Exc, Enter Fill
Enter
Please Set Ink
Enter
Ink Charge
n
Move the cursor to the right with "SelecType" key.
n
Move the cursor to the left with "Item" key.
n
Cursor move to the left edge when you press the "SelecType" key at the right
edge.
Self-Diagnostics
Select the proper value with
"Paper Feed+/-" key.
Select the proper value with
"Paper Feed+/-" key.
Select the proper value with
"Paper Feed+/-" key.
Press the [Enter] key to select
the Adjust top menu.
Press the [Enter] key to select
the Adjust top menu.
Press the [Enter] key to select
the Adjust top menu.
If the cartridge is not installed, left
hand of the message will appears.
Figure 5-50.
Revision B
234