Loading Tabbed Sheets In Multi-Sheet Bypass Tray - Konica Minolta 7085 Instruction Manual

Loading Tabbed Sheets in Multi-Sheet Bypass Tray

Rear
Front
Rear
Front
The tab extension width should be 12.5mm or less.
1.
Open the Multi-sheet bypass tray located on the right side of the
copier.
2.
Load tabbed sheets as illustrated above.
3.
Adjust the paper guides to the paper size.
4.
Specify the paper type as TAB for the Multi-sheet bypass tray.
See p. 3-29 to p. 3-31 for specifying the paper type of the Multi-sheet
bypass tray.
2-30
Example: 3 Tabbed sheets loaded in position for one finished set.
Section 1
Introduction
Printed
side
Example: 9 Tabbed sheets loaded in position for 3 finished sets.
Section 1
Section 1
Introduction
Section 1
Introduction
Printed
Introduction
side
Reminder!
HINT
Loading Paper (continued)
1st TAB
Section 1
Introduction
2nd TAB
3rd TAB
ONE FINISHED SET
1st TAB
1st TABS
2nd TABS
Section 1 Section 1
Introduction Introduction
3rd TABS
3rd TAB
3 FINISHED SETS
1st TAB
2nd TAB
3rd TAB
2nd TAB
Section 1
Introduction