Parallel Cable; Ac Power Cord - Xerox WorkCentre 385 Service Manual

Parallel Cable

The WorkCentre 385 parallel interface port allows you to use it with your
personal computer. It is recommended that the parallel cable supports IEEE-
1284 bi-directional communications.
To connect the printer to the computer, follow the steps below:
1. Make sure that both the Xerox Work Centre 385 and the computer are
turned off.
2. Plug the cable into the connector on the back of the printer. Push the metal
clips to fit inside the notches on the cable plug.
3. Connect the other end of the cable to the parallel interface port on your
computer. See your computer documentation if you need help.
Printer Cable & AC Power Cord

AC Power Cord

1. Plug one end of the cord into the back of the machine and the other end
into a standard AC power outlet.
The machine turns on. If there is no cartridge installed, or no paper, the
display shows "DOOR OPEN or NO TONER!!!" or [NO PAPER].
2. If you want to turn it off, unplug the power cord.
12/98
www.printcopy.info
1 - 6
To AC
Outlet
WorkCentre 385