Stop Or Correct A Copy Job - Oce VarioPrint 2050-70 Job Manual

Stop or correct a copy job

Introduction
A copy job has the following phases (see 'Copy jobs in this manual' on
page 30).
The information of the originals is scanned, digitised and converted in an
1
image.
The images are printed.
2
The bins collect the sets.
3
The table below shows the actions to take when you stop or correct a phase.
When
You notice an incorrect setting for
the copy job
The scan process of a job or a job part
fails (phase 1)
The printed sets are incorrect and the
job is not yet finished (phase 2 and 3)
You can interrupt the copy process before it has finished, to start a new
Note:
job. The suspended job is continued after the new job has finished (see
'Interrupt a copy job' on page 62).
How to correct: when you make the copy job settings
If you press the Correction key
Once
How to stop: during the scanning process
If you press the Correction key
Once
60 Océ VarioPrint 2050-70 Job manual
Then
Correct the copy job settings.
Stop the scanning process.
Stop the printing process.
Then
The Océ VarioPrint 2050-70 restores
the default settings.
Then
The Océ VarioPrint 2050-70 cancels
the copy job.